YELKENCIDESIGN UNO KIT CAR TUBE CHASSIS HAYABUSA ENGINE SWAP

This is an uno kit car tube chassis design with 1.3-liter Hayabusa engine swap. EVERYTHING MODELED FROM SCRATCH BY YELKENCIDESIGN. This 3d design would be around 350+hp in real life. (The engine that I modeled using single turbo charger and nitrous oxide) A stock uno is around 1000kg average. I assume this build with the body kit would be around 5/4 or 6/5 of its stock weight (maybe even lower. Probably lower) Everything modeled from scratch and most of the parts are custom design including suspension setup, chassis and more. For the handbrake I modeled Voodoo13usa racing handbrake. For the pedals I modeled Wilwood racing pedals. For the steering wheel. I redesigned* the original steering wheel (* I used almost original proportions of the stock steering wheel but mixed it with modern technology like buttons for start/stop, gear up/down...) It only has paddle shifters for gear up/down. I redesigned the wheels (used original/stock design of the rims (since the stock ones are not going to be strong or light enough to just cut and make it deep dish. Probably has to be rebuild real life) I was going to keep the engine bay clean but I wanted it to look more realistic and complicated so I keep the battery and wirings out (ı was going to put them into the dash but it would also not be really practical to reach in an emergency) I specifically didn't use any brand for suspension (inspired from rally suspensions. Lots of reference pictures used) Used Advan racing tires. (Rally suspension and racing tires are a great combo, right?) For the seats of course I used legendary brand Recaro. For this build my main inspirations were Renault R5 Turbo 3E and Lancia Delta s4. You can really see the vibe of them on the body kit.